Cindy - PM - 1.5 HR - Robot Club

Today in open lab, we measured and cut up the three side pieces for the top of the Tardis. We had one 25in. by 9in., one 24 in. by 3in., and one 23in. by 3in. piece foam boards. We had to over measure the foam boards since the foam melts as we cut it with a hot knife. After we were done cutting the foam boards out, we measured the other side of the top of the Tardis and recorded measurements for the other side as well as started tracing on the foam board. Next time in open lab, we are going to cut out the foam boards and sandpaper the edges.