- Worked on 37 sensors
- Created 3 "what you need to know" slides
What worked
- Using the snipping tool to take the slide layout and flip the background image.
- Used iPad to draw onto the materials image
- Crossed out motor controller, wrote "you don't need this"
- Wrote six steps
- From "place Reed Switch in breadboard" to "bring magnet close by and watch serial monitor"
- Wanted to make the presentation in a way where the picture would stay halfway on one slide and half way on another, but there wasn't the right animation that I wanted.
- Border colors for pictures don't look very good
What I'm going to do next time
- Finish more steps
- Change colors on borders to something brighter.
No comments:
Post a Comment