I measured the dimensions of the motor, the bit, and the case it self. These are the measurements I found:
Bit: The base is 0.3 cm while the tip is 0.2 cm (20 mm). The length of the bit is 33 mm.
Case: 30 mm * 30 mm * 50 mm
Motor: 25 mm * 25 mm * 55 mm
Before I started I looked at some tinkercad shortcuts to help me remember how to use tinkercad.
I then constructed the case of the motor. One side has a smaller hole and the other side has a larger hole.
Tomorrow I plan to 3D print the case and make any needed adjustments.
No comments:
Post a Comment