Cindy - PM - 1 HR - Robot Club Tardis

Today in open lab, we trimmed 2.5in out of the 48in. by 5in. piece of foam. After that, we got the three front pieces of the top of the Tardis and sandpapered its edges. Then, we placed and marked the three pieces of foam on top of each other in a staircase manner and marked down where we plan on gluing them down to each other. After that, we measured the side pieces for the Tardis. The measurements were one 24in. by 10in., one 23in. by 3in., and one 22in. by 3in foam boards. Next time when we work on the Tardis, we are going to draw the measurements onto the foam board and cut them out with a hot knife.